| Inspection |
| 1. |
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
|
| 2. |
Connect positive (+) battery cables to terminal 2 and negative (-) battery cables to terminal 1 respectively. |
| 3. |
Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles. |
| 4. |
If they are abnormal, replace the washer motor.
[Front & Rear Washer]
|
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Drain the washer fluid less than 650 cc. |
| 3. |
Check for continuity between the No. 1 and No.2 terminal in each float position.
There should be continuity when the float is down.
There should be no continuity when the float is up. |
| 4. |
If the continuity is not as specified, replace the washer fluid level switch
|
| 5. |
If the continuity is not as specified, replace the washer fluid level switch (A).
|
| Removal |
|
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the right front wheel guard.
(Refer to Body - "Front Wheel Guard") |
| 3. |
Remove the engine room under cover
(Refer to Engine Mechanical System - "Engine Room Under Cover") |
| 4. |
Remove the washer hose (B) and disconnect the washer motor connector (A).
|
| 5. |
Remove the reservoir washer inlet (A) after loosening the mounting bolt.
|
| 6. |
Remove the washer motor (A) and level sensor switch (B).
|
| Installation |
| 1. |
Install the washer reservoir.
|
| 2. |
Install the washer motor. |
| 3. |
Install the washer hose. |
| 4. |
Connect the washer motor connector and level sensor connector. |
| 5. |
Install the tire and wheel guide cover.
(Refer to Body - "Front Wheel Guard") |
| 6. |
Install the engine room under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover") |
| 7. |
Check the washer motor operation. |
Front Wiper Motor Repair proceduresRemoval 1. Disconnect the negative (-) battery terminal. 2. If necessary, release the wiper blade fixing clip by pulling up and remove the wiper blade from the inside radius of wiper arm...
Electro Chromic Inside Rear View MirrorComponents and Components Location Components (1) Components (2) Components (3) Description and Operation Description The ECM (Electro Chromatic inside rear view Mirror) is intended dim the reflecting light in the rear view mirror...
Component Location Index Engine Room [Theta 2.4 GDI] 1. Receiver-drier2. Condenser3. Service Port (High Pressure)4. Service Port (Low Pressure)5. A/C Pressure Transducer (APT)6. Compressor7. Suction & Liquid Tube Assembly8. Expansion Valve9...
Components and Components Location Components 1. Windshield glass 2. Windshield moulding mounting bracket3. Windshield glass side moulding4. Windshield glass upper moulding Repair procedures Removal • Put on gloves to protect your hands...