| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Disconnect the accelerator position sensor connector (A).
|
| 3. |
Remove the mounting cap (A).
|
| 4. |
Remove the installation bolt (A), and then remove the accelerator pedal module.
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Filler-Neck Assembly Repair proceduresRemoval 1. Turn the ignition seitch OFF and disconnect the battery negative (-) cable. 2. Open the fuel filler door and then remove the filler-neck installation screw (A)...
Delivery Pipe Repair proceduresRemoval In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel...
Removal 1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2. Remove the rear seat cushion. (Refer to Body - "Rear Seat Assembly") 3. Remove the fuel pump service cover (A) in the trunk...
R..