| Removal |
| 1. |
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - "Release Residual Pressure in Fuel Line") |
| 2. |
Remove the rear seat cushion.
(Refer to Body - "Rear Seat Assembly") |
| 3. |
Remove the fuel pump service cover (A) in the trunk.
|
| 4. |
Disconnect the fuel feed tube quick-connector (A). |
| 5. |
Disconnect the fuel pressure sensor connector (B). |
| 6. |
Disconnect the fuel pump control module (C).
|
| 7. |
Lift the vehicle. |
| 8. |
Remove the main muffer.
(Refer to Engine Mechanical System - "Muffler") |
| 9. |
Support the fuel tank with a jack. |
| 10. |
Disconnect the fuel filler hose (A). |
| 11. |
Disconnect the vapor hose quick-connector (A).
|
| 12. |
Disconnect the fuel tank pressure sensor extension connector (A).
|
| 13. |
Remove the fuel tank bands (A) installation nuts.
|
| 14. |
Remove the fuel tank after removing the fuel tank band (A) as below.
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Repair proceduresFuel Pressure Test (Low pressure system) 1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line")...
Fuel Pump Repair proceduresInspection [Fuel sender] 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel pump assembly. 3. Using an ohmmeter, measure the resistance between terminals 1 and 6 of sender connector (A) at each float level...
Component Location 1. Blower unit assembly Components 1. Intake actuator2. Intake case [LH]3. Intake door assembly4. Air filter5. Filter cover assembly6. Intake inlet seal 7. Intake case [RH]8. Intake outlet seal 9. Blower upper cover10. Blower unit pad11...
C..