Hyundai Sonata LF: Fuel Delivery System / Filler-Neck Assembly Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures

Removal
1.
Turn the ignition seitch OFF and disconnect the battery negative (-) cable.
2.
Open the fuel filler door and then remove the filler-neck installation screw (A).

3.
Lift the vehicle.
4.
Remove the rear-LH wheel, tire, and the inner wheel house.
5.
Remove the rear sub frame.
( Refer to Suspension System - " Rear Sub Frame ")
6.
Disconnect the canister close valve connector (A).

7.
Disconnect the fuel filler hose (A).
8.
Disconnect the ventilation hose (B) from the fuel tank air filter.

9.
Remove the filler-neck assembly from the vehicle after removing the bracket installation bolt (A).

Installation
1.
Install in the reverse order of removal.

Filler-neck assembly bracket installation bolt :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Filler-neck assembly installation screw :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lbf.ft)

    Fuel Line Repair procedures

    Removal     Whenever the high pressure fuel pump, fuel pipe, deliverypipe, or injector is removed immediately after shutting offthe engine, an injury may be caused by the release ofhighly pressurized fuel...

    Accelerator Pedal Repair procedures

    Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A)...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Specifications


    Specifications Transmission typeD7UF1Egnine typeGasoline 1.6 T-GDITransmission fluidQuantity1.9 ~ 2.0 LSpecified lubricantAPI Service GL-4, SAE 70W• Recommended oil - SHELL: SPIRAX S6 GHME 70W DCTF - SK: HK DCTF 70W - GS CALTEX: GS DCTF HD 70W Gear ratio1st3...

    Hyundai Sonata LF 2014-2019 Service Manual: Brake Booster Repair procedures


    Brake Booster Operating Test For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses fully the first time but gradually becomes higher when depressed succeeding times, the booster is operating properly, if the pedal height remains unchanged, the booster is inoperative...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org