| Circuit Diagram |

Heated Oxygen Sensor (HO2S) SpecificationsSpecification HO2S [Bank 1/Sensor 1] (Linear type) ItemSpecificationHeater Resistance (?)2.4 ~ 4.0 [20°C(68°F)] ItemSpecificationHeater Resistance (?)Approx...
Heated Oxygen Sensor (HO2S) Repair proceduresInspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 2 and 5 [B1/S1]...
Removal 1. Turn the ignition seitch OFF and disconnect the battery negative (-) cable. 2. Open the fuel filler door and then remove the filler-neck installation screw (A). 3. Lift the vehicle. 4. Remove the rear-LH wheel, tire, and the inner wheel house...
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. Specification: Refer to "Specification" Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable...