| Inspection |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Remove the crash pad side switch assembly.
|
| 3. |
Check the continuity between the switch terminals as the ESP OFF switch is engaged.
|
Steering Angle Sensor SpecificationsSpecification Service Standard DescriptionSpecificationOperating voltage8 ~ 16VOperating temperature-40 ~ 85°C(-40 ~ 185°F)Current consumptionMax...
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4. Verify that the mode control actuator operates to the vent mode when connected in reverse...
Inspection Transmission Control Module (TCM) Inspection Procedure 1. Inspecting TCM ground circuit: Measure the resistance between the TCM and chassis ground. (Check the terminal connected to the chassis ground while using the back of the harness connector as the base point for TCM...