| Removal and Installation |
| 1. |
Loosen the mounting clip and bolt and then remove the under cover (A).
|
| 2. |
Install in the reverse order of removal. |
Inspection 1. Fuse inspection Mount the test fuse to the switch fuse and relay fuse part to confirm a normal joint fit. 2. Inspection of connector by each part Check to see whether or not each connector has been damaged, or terminal surge, or incomplete connection has taken place [Engine room junction box] [Stop signal electronic module] [ABS/VDC control module] 3...
Components and Components Location Component Location 1. Fender assembly Repair procedures Replacement • Be careful not to damage the fender and body. • When removing the clips, use a clip remover...