Timing Chain Repair proceduresRemoval 1. Turn the crankshaft pulley clockwise, and align its groove with the timing mark of the timing chain cover. 2. Remove the timing chain cover...
Components and Components LocationComponents 1. Cylinder head cover2. Cylinder head cover gasket3. Cylinder head assembly4. Cylinder head gasket5. Camshaft position sensor6. Camshaft bearing cap7...
Projected Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Actual Measurement Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front side member tooling hole (O25)Side cover mounting hole (O9)Front sub frame mounting boltCenter floor side member tooling hole (O11)Center floor side member tooling hole (O16)Floor under cover mounting hole (O6...
Troubleshooting Ignition System SymptomSuspect AreaRemedyEngine will not start or is hard to start (Cranks OK)Ignition lock switchInspect ignition lock switch, or replace as requiredIgnition coilInspect ignition coil, or replace as requiredSpark plugsInspect spark plugs, or replace as requiredIgnition wiring disconnected or brokenRepair wiring, or replace as requiredRough idle or stallsIgnition wiringRepair wiring, or replace as requiredIgnition coilInspect ignition coil, or replace as requiredEngine hesitates/poor accelerationSpark plugs and spark plug cablesInspect spark plugs / cable, or replace as requiredIgnition wiringRepair wiring, or replace as requiredPoor mileageSpark plugs and spark plug cablesInspect spark plugs / cable, or replace as required Charging System SymptomSuspect AreaRemedyCharging warning indicator does not light with ignition switch "ON" and engine off...