Hyundai Sonata LF: Crash Pad / Steering Column Shroud Panel Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Body (Interior and Exterior) / Crash Pad / Steering Column Shroud Panel Repair procedures

Replacement
[Steering Column Shroud Upper Panel]
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Lower the steering wheel.
2.
Using a screwdriver or remover, remove the steering column shroud upper panel (A).

3.
Install in the reverse order of removal.
   
•
Replace any damage clips.
[Steering column shroud lower panel]
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the crash pad lower panel.
(Refer to Crash Pad - "Crash Pad Lower Panel")
2.
After loosening the mounting screws, then remove the steering column shroud lower panel (A).

3.
Install in the reverse order of removal.
   
•
Replace any damage clips.

    Steering Column Shroud Panel Components and Components Location

    C..

    Crash Pad Side Cover Components and Components Location

    C..

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Engine Oil Repair procedures


    Replacement     • Prolonged and repeated contact with mineral oil will result in the removal of natural fats from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer...

    Hyundai Sonata LF 2014-2019 Service Manual: SRS Control Module (SRSCM) Repair procedures


    Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console. (Refer to Body - "Floor Console Assembly") 4. Pull up the lock (C), of the SRSCM connector, then disconnect the connector (A and B)...

    Categories

    read more

     
    Copyright © 2025 www.hsonatalf.org