Hyundai Sonata: AVN System / AVN Remote Controller (Sonata Sports) Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Body Electrical System / AVN System / AVN Remote Controller (Sonata Sports) Repair procedures

Inspection
1.
Check for resistance between terminals in each switch position (LH).

[LH : Audio + Hands free]
Switch
Connector
Terminal
Resistance
(±5%)
SEEK Up
4-5
430 ?
SEEK Down
1.11 k?
MUTE
3.11 k?
Volume (+)
4.61 k?
Volume (-)
6.81 k?
Voice
10.71 k?
SEND
18.91 k?
END
40.91 k?

2.
Check for resistance between terminals in each switch position (RH).

[RH : Audio + Hands free]
Switch
Connector
Terminal
Resistance
(±5%)
Cancel
4-5
330 ?
SET (-)
550 ?
RES (+)
880 ?
Cruise ON/OFF
1.44 k?
SCC (Following distance control)
5.54 k?
Group
2-4
560 ?
Trip Up
890 ?
Trip Down
1.45 k?
ENTER
2.55 k?

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel assembly.
(Refer to Steering System - "Steering Wheel")
3.
Remove the screw from the steering cover.

4.
Remove the steering back cover (A).

5.
Remove the steering remote control connector (A).

6.
Remove the steering remote control (A) after loosening the screws.

Installation
1.
Install the steering wheel remote control after connecting the connector.
2.
Connect the negative (-) battery terminal.
AVN Remote Controller (Sonata Sports) Schematic Diagrams
Circuit Diagram ...

AVN Antenna Components and Components Location
Components ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Temperature Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7. Verify that the temperature control actuato ...

Hyundai Sonata LF 2014-2019 Service Manual: Crankshaft Position Sensor (CKPS) Repair procedures
Inspection 1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform” Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) af ...

© 2018-2025 www.hsonatalf.org