Hyundai Sonata: Rear Bumper / Rear Bumper Beam Assembly Components and Components Location

Hyundai Sonata LF 2014-2019 Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper Beam Assembly Components and Components Location

Component Location

1. Rear bumper beam assembly


Rear Bumper Cover Repair procedures
Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with ...

Rear Bumper Beam Assembly Repair procedures
Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Crankshaft Damper Pulley Repair procedures
Removal and Installation 1. Remove the drive belt. (Refer to Timing System - "Dreve Belt") 2. Remove the engineroom under cover. 3. Remove the passenger side front tire. 4. Remove the crankshaft damper pulley (A). Tightening torque : (47.0 ~ 50.9 N.m) + (38°~ 42°) [(4.8 ~ 5.2 ...

Hyundai Sonata LF 2014-2019 Service Manual: Side Body Body Repair
Side Body A * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side Body B * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Fender apron tooling hole (O7)Fender apron panel tooling hol ...

© 2018-2025 www.hsonatalf.org