| Inspection |
| 1. |
Remove the cowl top cover.
(Refer to Body - "Cowl Top Cover") |
| 2. |
Disconnect the windshield deicer connector (A).
|
| 3. |
Check for continuity between the terminals of deicer lines.
|
| 4. |
Turn the ignition switch ON and the windshield deicer switch
ON, then measure the voltage between the terminals of harness side
deicer connector.
|
Components and Components LocationComponent Location Windshield deicer system prevent windshield wiper from freezing in the winter season. It consists of deicer in the lower part of windshield, switch and relay...
Windshield Deicer Switch Repair proceduresInspection 1. The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS). The diagnostic system (GDS) provides the following information...
Troubleshooting Trouble symptomProbable causeRemedyDisplayed the warning lamp "E"(Driving is only possible with 1/ R gear)Not performed DCT learningPerform the DCT manual learning procedure.Impossible to driving with odd gearClutch actuator (Clutch motor 1 or position sensor 1 failure)Replace the clutch actuator assembly...
Removal 1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the front seat. (Refer to Body - "Front Seat Assembly") 3. Remove the rear seat. (Refer to Body - "Rear Seat Assembly") 4...