| Description |
Never attempt to measure the circuit resistance of the airbag
module (squib) even if you are using the specified tester. If the
circuit resistance is measured with a tester, accidental airbag
deployment will result in serious personal injury. |
Passenger Airbag (PAB) Module Repair proceduresRemoval 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the glove box housing. (Refer to Body - "Glove Box Upper Cover Assembly") 3...
Components and Components Location Component Location 1. Panorama sunroof2. Panorama sunroof switch3. Panorama sunroof motor & controller4. Roller blind motor & slave controller Schematic Diagrams Circuit Diagram NoSunroof wiringconnector(Vehicle side)Sunroof wiringconnector(Motor)Panorama glass motor(Master)Blind motor(Slave)1GND 1 GND 1GND 22Glass statussignal / tool(parameter)Glass status signal / tool(parameter)Blind signal3BCM EnableBCM Enable-4Tilt up switchTilt up switch-5GND 2--6BATT 1BATT 1BATT 27---8Vehicle speed signalVehicle speed signalVehicle speed signal9Glass open switch Glass open switchBlind open switch10Glass close switch Glass close switchBlind close switch11BATT 212Blind open switch 13Blind close switch 14Blind signal Panorama Sunroof Switch Components and Components Location Components Panorama Sunroof Switch Repair procedures Inspection 1...
Side Body A * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side Body B * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Fender apron tooling hole (O7)Fender apron panel tooling hole (O7)Front door upper hinge mounting hole (O13)Front door lower hinge mounting hole (O13)Rear door upper hinge mounting hole (O13)Rear door lower hinge mounting hole (O13)Quarter panel tooling hole (O14)Quarter fixed glass mounting hole (O5...