Hyundai Sonata: Cooling System / Water Temperature Control Assembly Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Repair procedures

Removal and Installation

1.	Loosen the drain plug, and drain the engine coolant. Remove the radiator cap to drain with speed.

2.	Disconnect the battery negative terminal.

3.	Remove the air cleaner assembly. (Refer to Intake and exhaust system - "Air Cleaner")

4.	Disconnect the water temperature sensor connector (A).

5.	Disconnect the radiator upper hose (B).

6.	Remove the heater hose (C).

7.	Disconnect the water hose (D).

Remove the water temperature control assembly (B).

Tightening torque :

9.8 ~ 11.7N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)

Install in the reverse order of removal.

Clean the surface of the water temperature control assembly before installing.

Water Temperature Control Assembly Components and Components Location

Components 1. Water temperature control assembly2. Water temperature sensor3. Gasket ...

Water Pipe Components and Components Location

Components 1. Water pipe ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Troubleshooting
Troubleshooting • The battery must be in good condition and fully charged for this troubleshooting. ...

Hyundai Sonata LF 2014-2019 Service Manual: General Information
General 1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is no elongation, twisting or bending. 3. For measuring dimensions, both projected dimension and actual-measurement dimension are used in thi ...