| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Using a screwdriver or remover, Separate the room lamp lens (A) from the room lamp.
|
| 3. |
If it is necessary to replace the bulb, remove the bulb (A) after disengaging the room lamp lens. |
| 4. |
Disengage the room lamp (B) after loosening the mounting screws.
|
| 5. |
Remove the room lamp assembly after disconnect the room lamp connector. |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Separate the room lamp (B) from the roof trim after disengaging the mounting clip (A).
|
| 1. |
Separate the vanity Lamp (B) from the roof trim after disengaging the mounting clip (A).
|
| Installation |
| 1. |
Install the room lamp after connect the connector. |
| 2. |
Install the room lamp lens |
| 3. |
Connect the negative (-) battery terminal. |
| 1. |
Install the room lamp after connect the connector. |
| 2. |
Connect the negative (-) battery terminal. |
| 1. |
Install the vanity lamp. |
| 2. |
Connect the negative (-) battery terminal. |
Head Lamps Repair proceduresInspection 1. Check the battery voltage. (Low beam will be on when the battery voltage above 9V.) 2. Check the fuse and relay. 3. Check the polarity of ballast...
Overhead Console Lamp Repair proceduresInspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch...
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...
Specifications Smart Key Unit ItemsSpecificationRated voltageDC 12VOperating voltageDC 9 ~ 16VOperating temperature-22°F ~ 176°F (-30°C ~ 80°C)LoadMax. 4mA (When welcome light function off) RF Receiver ItemsSpecificationFrequency433.92 MhzAntenna typeFSK (Frequency Shift Keying) Smart Key Fob ItemsSpecificationBatteryLithium battery 3V 1EADistance30m from vehicle, RF : 30m, Passive(LF) : 0...