| Removal and Installation |
| 1. |
Remove the water temperature control assembly.
(Refer to Colling System - "Water Temperature Control Assembly") |
| 2. |
Remove the water pipe (A).
|
| 3. |
Install in the reverse order of removal. |
Inspection [Fuel sender] 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel pump assembly. 3. Using an ohmmeter, measure the resistance between terminals 1 and 6 of sender connector (A) at each float level...
Removal 1. Turn the ignition switch OFF. 2. Pull up the lock of the HECU connector , then disconnect the connector. 3. Disconnect the brake tubes from the HECU by unlocking the nuts counterclockwise with a spanner. Tightening torque : ABS : 13...