Hyundai Sonata: Ignition System / Spark Plug Repair procedures
1. |
Accelerate the engine to about 3,000 rpm 3 times or more. |
2. |
Remove the spark plug. |
3. |
Check the spark plug visually.
If the electrode is dry, the spark plug is normal.
If the electrode is wet, check the damage and electrode gap as below. |
1. |
Check the spark plug for any damage on its thread and insulator.
If there is damage, replace the spark plug. |
2. |
Check the electrode. Measure the insulation resistance with an ohmmeter.
If the resistance is less than the specified value, adjust the electrode gap.
Specification: 10 M? or more
|

|
3. |
Check the spark plug electrode gap.
If the gap is greater than the maximum, replace the spark plug.
Specification: 0.7 ~ 0.8 mm ( 0.0275 ~ 0.0314 in.)
|
• |
If adjusting the gap of a new spark plug, bend only the base of the ground electrode. Do not touch the tip.
Never attempt to adjust the gap on a used plug. |
|

|
The combustion temporarily becomes unstable, due to the aged
fuel and the carbon deposits accumulated on the spark plug(s) after
long-term storage.
1. |
Start the engine and keep the engine running at idle for 2 minutes. |
2. |
Step on the accelerator pedal and hold it steady at 4500 rpm
with the shift lever in N position to warm up the engine until the
temperature of the engine coolant reaches 80°C. |
3. |
Keep the engine running at 2500~3000 rpm in the N position for 15 minutes. 
|
• |
The 2nd method should be performed only if the 1st method fails (the misfire-related codes recur).
|
|
1. |
Start the engine and keep the engine running at idle for 2 minutes. |
2. |
Drive the vehicle for over 20 minutes, keeping the engine speed above 3500 rpm.
• |
If equipped with manual transaxle, shift the gear properly for keeping the engine speed above 3500 rpm. |
|

|
1. |
Remove the ignition coil.
(Refer to Ignition System - "Ignition Coil") |
2. |
Using a spark plug wrench, remove the spark plug (A).
• |
Be careful that no contaminates enter into spark plug holes. |
|

|
1. |
Install in the reverse order of removal.
Tightening torque:
14.7 ~ 24.5 N.m (1.5 ~ 2.5 kgf.m, 10.9 ~ 18.0 Ib-ft)
|
|
Specification
ItemSpecificationTypeSILZKR7E8GGap0.7 ~0.8 mm (0.0275 ~ 0.0314 in.)
...
Other information:
Hyundai Sonata LF 2014-2019 Service Manual: Towing
General Information
If the vehicle needs to be towed, call a professional towing
service. Never tow vehicle with just a rope or chain. It is very
dangerous.
Emergency Towing
There are three popular methods of towing a vehicle :
-
The operator loads the vehicle on the back of truck. Th ...
Hyundai Sonata LF 2014-2019 Owners Manual: To set Smart Cruise Control speed
1. Push the CRUISE button on the steering wheel to turn the system on. The CRUISE
indicator will illuminate.
2. Accelerate to the desired speed.
The Smart Cruise Control speed can be set as follows:
20 mph (30 km/h)~110 mph (180 km/h): when there is no vehicle in front
0 mph (0 km/h)~110 mph (1 ...