Hyundai Sonata LF: Ignition System / Spark Plug Specifications

Hyundai Sonata LF 2014-2019 Service Manual / Engine Electrical System / Ignition System / Spark Plug Specifications

Specification
Item
Specification
Type
SILZKR7E8G
Gap
0.7 ~0.8 mm (0.0275 ~ 0.0314 in.)

    Spark Plug Description and Operation

    Description A spark plug is a device for delivering electric current from an ignition system to the combustion chamber of a spark-ignition engine to ignite the compressed fuel/air mixture therein by means of an electric spark, while containing combustion pressure within the engine...

    Spark Plug Repair procedures

    Inspection [On vehicle inspection] 1. Accelerate the engine to about 3,000 rpm 3 times or more. 2. Remove the spark plug. 3. Check the spark plug visually...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Troubleshooting


    Troubleshooting SymptomSuspect AreaRemedy (Refer to page)Water leaks from panorama sunroofDirt accumulated in drain tubeClear dirt inside of drainClogged drain tubeBlow air into drain to remove dirtBroken or dislocated drain tube, defective or cracked clipCheck tube installation and flange contactDeteriorated roof lid weatherstripReplaceExcessive roof lid-to-body clearance and improperly fitted weatherstripAdjustWind noise around panorama sunroofLoosen or deformed deflector, gaps in body workRetighten adjust or replaceMisaligned weather stripReadjust or replace weather stripSunroof lid makes a noise when moveForeign particles lodged in guide railCheck drive cable and guide rails for foreign particlesLoosen guide rails and lidRetightenMotor runs but panorama sunroof does not move or moves only partiallyForeign particles lodged in guide railAdjust or replaceIncorrect engagement of motor pinion with drive cableDecrease in motor`s clutch slipping forceIncreased sunroof sliding resistance or interference of sunroof with drive cables, weatherstrip, etc...

    Hyundai Sonata LF 2014-2019 Service Manual: Purge Control Solenoid Valve (PCSV) Repair procedures


    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV terminals 1 and 2. 4. Check that the resistance is within the specification. Specification: Refer to “Specification” Removal 1...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org