| Inspection |
| 1. |
Troubleshooting for Speaker
| ||||||||||||||||||||||||||||||||||||||||||
| Removal |
| 1. |
Remove the front door trim.
(Refer to Body - "Front Door Trim") |
| 2. |
Remove the front door speaker (A) after disconnect the connector and loosening the screws.
|
| 1. |
Remove the Rear door trim.
(Refer to Body - "Rear Door Trim") |
| 2. |
Remove the rear door speaker (A) after disconnect the connector and loosening the screws.
|
Take care not to scratch the crash pad and related parts. |
| 1. |
Using a screwdriver or remover, remove the crash pad center speaker grille (A).
|
| 2. |
Remove the center speaker (A) after disconnect the connector and loosening the screws.
|
| 1. |
Remove the rear seat.
(Refer to Body - "Rear Seat") |
| 2. |
Remove the package tray trim.
(Refer to Body - "Rear Package Tray Trim") |
| 3. |
Remove the sub woofer speaker (A) after disconnect the connector and loosening the bolts.
|
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the left/right crash pad side speaker grille (A).
|
| 3. |
Remove the midrange speaker (A) after disconnect the connector and loosening the screws.
|
| Installation |
| 1. |
Install the front door speaker. |
| 2. |
Install the front door trim. |
| 1. |
Install the rear door speaker. |
| 2. |
Install the rear door trim. |
| 1. |
Install the center speaker. |
| 2. |
Install the center speaker grille. |
| 1. |
Install the midrange speaker |
| 2. |
Install the crash pad side speaker grille. |
| 3. |
Connect the negative (-) battery terminal. |
| 1. |
Install the subwoofer speaker. |
| 2. |
Install the rear package tray and rear seat. |
Make sure the speaker connectors are plugged in properly. |
Audio Unit Repair proceduresRemoval 1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia upper panal. (Refer to Body - "Cluster Fascia Upper Panel") 3...
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the center facia panel. (Refer to Heating, Ventilation and Air Conditioning - "Controller") 3. Remove the start/stop button (A) after loosening the screw (3EA). Installation 1...
Specifications DescriptionSpecificationsLimitGeneralTypeIn-line, DOHC?Number of cylinders4?Bore77mm (3.0315in)?Stroke85.44mm (3.3638in)?Total displacement1,591 cc (97.09 cu.in)?Compression ratio9.5 : 1?Firing order1-3-4-2?Valve timingIntake valveOpensATDC 8°/BTDC 42°?ClosesABDC 69°/ABDC 19°?Exhaust valveOpensBBDC 40°/BBDC 0°?ClosesATDC 3°/ATDC 43°?Cylinder headFlatness of gasket surfaceLess than 0...