Hyundai Sonata LF: Panorama Sunroof / Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Body (Interior and Exterior) / Panorama Sunroof / Repair procedures

Adjustment
Inspect Glass Alignment
1.
Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it.
Alignment adjustment
Standard value [mm(in.)]
(1) Front edge : 0 mm (0 in.)
(2) Rear edge : 0 mm (0 in.)

2.
Completely open the movable glass using the panorama sunroof switch.
3.
Remove both sides of the decoration cover (A).

4.
Completely close the movable glass using the panorama sunroof switch.
5.
Adjust the height of the glass by slighty loosening the screws (A).
   
•
Be careful not to damage the screw.

Emergency operation
1.
Use the panorama sunroof emergency operation only when you have to open or close the sunroof when there is a problem with the engine.
2.
Use a hexagon wrench to open or close the panorama sunroof after removing the roof trim. Do not apply too much force when opening or closing the panorama sunroof.
[Movable Glass Motor "A"]

[Roller Blind Motor "B"]

3.
If needed reset the panorama sunroof according to the reset method.

    Components and Components Location

    Components 1. Glass motor2. Roller blind motor3. Mechanism assembly4. Front decoration cover 5. Wind deflector6. Center cover assembly7. Roof side moulding8...

    Movable Glass Repair procedures

    Replacement 1. Completely open the movable glass using the panorama sunroof switch. 2. Remove both sides of the decoration cover (A). 3. Completely close the movable glass using the panorama sunroof switch...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Door Mood Lamp Repair procedures


    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front Door Trim") 3. Disconnect the door mood lamp connector. 4. Remove the door mood lamp (A). Installation 1. Install the door mood lamp and connector...

    Hyundai Sonata LF 2014-2019 Service Manual: Oil Pump Repair procedures


    Removal and Installation 1. Remove the timing chain cover. (Refer to Timing System - "Timing Chain Cover") 2. Remove the pump cover (A). Tightening torque : 8.8 ~ 13.7N.m (0.9 ~ 1.4kgf.m, 6.5 ~ 10.1 lb-ft) 3. Remove the inner rotor (B) and outer rotor (C)...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org