| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim") |
| 3. |
Disconnect the door mood lamp connector. |
| 4. |
Remove the door mood lamp (A).
|
| Installation |
| 1. |
Install the door mood lamp and connector. |
| 2. |
Install the front door trim. |
| 3. |
Connect the negative (-) battery terminal. |
Overhead Console Lamp Repair proceduresInspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch...
Hazard Lamp Switch Repair proceduresInspection 1. Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch. AVN typeAudio typeNoDescription NoDescription 1GND1GND 2CAN _ High 2-3CAN _ Low 3- 4- 4-5Detent 5Detent 6ACC6Acc 7Battery (+)7Battery (+)8PAB Off 8PAB Off 9- 9Illumination (-)10- 10Illumination (+) 11SBR _ PS 11SBR PS 12- 12- 13Hazard lamp switch 13Hazard lamp switch 14- 14- 15IGN (+)15IGN (+)16- 16- Removal • Wrap the protective tape on the tool to disassemble with the screwdriver or remover...
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the fuel tank. (Refer to Engine Control / Fuel System - " Fuel Tank") 3. Disconnect the vent hose (A). 4. Disconnect the vapor tube quick-connector (B,C)...
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group). 3. Disconnect the injector connector (A). 4. Remove the installation bolt (B), and then remove the sensor from the cylinder block...