| Replacement |
| 1. |
Completely open the movable glass using the panorama sunroof switch. |
| 2. |
Remove both sides of the decoration cover (A).
|
| 3. |
Completely close the movable glass using the panorama sunroof switch. |
| 4. |
Adjust the height of the glass by slighty loosening the screws (A).
|
| 5. |
Carefully lift up the movable glass (A) and then remove it.
|
| 6. |
Install in the reverse order of removal.
|
Repair proceduresAdjustment Inspect Glass Alignment 1. Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it...
Front Glass Repair proceduresRemoval • In order to remove the front glass, use the tools shown in the following figure: [Tooling Diagram] Square wire Insert-type wire grip [Tooling Assembly Diagram] • Insert and affix square wire into the insert hole of the wire grip ...
Self Diagnosis 1. Self-diagnosis process. • When operating the self-diagnostics, the below fault (self-diagnostics code) will blink at 0.5 seconds interval on the temperature display settings (driver's side only) and the remaining symbols are OFF ...
Specification [EWGA Position Sensor] Position Output Voltage[V] Operating Angle[°] Range of Rod [mm], reference Mechanical Close end stop Position (MCP) 4.8 0 0 Electrical Close end stop Position (ECP) 4.2 12 1.8 Electrical Open end stop Position (EOP) 1 79 16 Mechanical Open end stop Position (MOP) 0...