Hyundai Sonata LF: Panorama Sunroof / Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Body (Interior and Exterior) / Panorama Sunroof / Repair procedures

Adjustment
Inspect Glass Alignment
1.
Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it.

Alignment adjustment
Standard value [mm(in.)]
(1) Front edge : 0 mm (0 in.)
(2) Rear edge : 0 mm (0 in.)

2.
Completely open the movable glass using the panorama sunroof switch.
3.
Remove both sides of the decoration cover (A).

4.
Completely close the movable glass using the panorama sunroof switch.
5.
Adjust the height of the glass by slighty loosening the screws (A).
   
•
Be careful not to damage the screw.

Emergency operation
1.
Use the panorama sunroof emergency operation only when you have to open or close the sunroof when there is a problem with the engine.
2.
Use a hexagon wrench to open or close the panorama sunroof after removing the roof trim. Do not apply too much force when opening or closing the panorama sunroof.
[Movable Glass Motor "A"]

[Roller Blind Motor "B"]

3.
If needed reset the panorama sunroof according to the reset method.

    Components and Components Location

    Components 1. Glass motor2. Roller blind motor3. Mechanism assembly4. Front decoration cover 5. Wind deflector6. Center cover assembly7. Roof side moulding8...

    Movable Glass Repair procedures

    Replacement 1. Completely open the movable glass using the panorama sunroof switch. 2. Remove both sides of the decoration cover (A). 3. Completely close the movable glass using the panorama sunroof switch...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Fuel Pump Repair procedures


    Inspection [Fuel sender] 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel pump assembly. 3. Using an ohmmeter, measure the resistance between terminals 1 and 6 of sender connector (A) at each float level...

    Hyundai Sonata LF 2014-2019 Service Manual: SRS Control Module (SRSCM) Description and Operation


    Description The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does not. The SRSCM must decide whether to deploy the restraint system or not...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org