| Replacement |
|
|
| 1. |
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly") |
| 2. |
After loosening the mounting screws, then remove the rear isofix bracket (A).
|
| 3. |
After removing the clips on the rear of seat cushion cover and remove the rear seat cushion cover (A).
[Front side]
[Rear side]
|
| 4. |
Install in the reverse order of removal.
|
Rear Back Armrest Repair proceduresReplacement • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...
Signal Waveform The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side (ground side) of the #1 injector and the bottom waveform is from the low side of the #4 injector...
Removal • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. 1. Disconnect the negative (-) battery terminal...