Hyundai Sonata LF: Cylinder Block / Rear Oil Seal Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Repair procedures

Removal

1.	Remove the transaxle assembly. (Refer to transaxle - "Manual Transaxle assembly, Auto Transaxle assembly")

2.	MT : Remove the flywheel. (Refet to Cylinder Block - "Flywheel")

3.	AT : Remove the drive plate. (Refet to Cylinder Block - "Drive Plate")

4.	Remove the rear oil seal (A).

Installation

Install the rear oil seal.

(1)	Apply engine oil to a new oil seal lip.

(2)	Using the SST (09231-H1100, 09231-2B200) and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

2.	MT : Install the flywheel. (Refet to Cylinder Block - "FlyWheel")

3.	AT : Install the drive plate. (Refet to Cylinder Block - "Drive Plate")

4.	Install the transaxle assembly. (Refer to transaxle - "Manual Transaxle assembly, Auto Transaxle assembly")

Rear Oil Seal Components and Components Location

C..

Cylinder Block Components and Components Location

Components 1. Cylinder block2. Ladder frame3. Crank shaft4. Crank shaft upper bearing5. Crank shaft lower bearing6. Thrust bearing7...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: RCV Control Solenoid Valve Description and Operation

Description RCV (Recirculation Valve) Control Solenoid Valve is installed on the cooling pan motor top and operates the RCV actuator which controls the by-pass passage of the turbo-charger compressor. When the throttle valve is closed during engine running [Tip-out], crash noise of the impeller will occur because of rapid increasing of the boost pressure...

Hyundai Sonata LF 2014-2019 Service Manual: Injector Troubleshooting