Stop Signal Electronic Module Repair proceduresInspection 1. Fuse inspection Mount the test fuse to the switch fuse and relay fuse part to confirm a normal joint fit. 2. Inspection of connector by each part Check to see whether or not each connector has been damaged, or terminal surge, or incomplete connection has taken place [Engine room junction box] [Stop signal electronic module] [ABS/VDC control module] 3...
Parking Brake Assembly Components and Components LocationComponents (1) 1. Parking brake pedal2. Parking brake cable3. Equalizer assembly Components (2) 1. Backing plate2. Brake shoe3. Shoe hold clip4...
General Information Tightening Torque Table Of Standard Parts BOLT (Nominal diameter)NUT (Nominal diameter) BOLT/NUT Thin screw Torque Nm (kg.m, Ib-ft) Nominal diameter. (mm)Pitch [mm (in.) ]4T8T10TM50.8 (0.031) 2.0 ~ 3.0 (0...
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front Door Trim") 3. Disconnect the door mood lamp connector. 4. Remove the door mood lamp (A). Installation 1. Install the door mood lamp and connector...