| Removal |
| 1. |
Turn ignition OFF and disconnect the negative (-) battery cable. |
| 2. |
Remove the floor console assembly.
(Refer to Body - “Floor console assembly") |
| 3. |
Remove the EPB switch after loosening the screws.
|
| 4. |
Install in the reverse order of removal. |
Electric Parking Brake (EPB) Repair proceduresEPB Release 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Connect the GDS to the data link connector located underneath the dash panel...
Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) When using an impact gun, final tightening torque should be checked using a torque wrench...
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the knee air bag. (Refer to Restraint - "Knee Airbag(KAB) Module") 4. Disconnect the stop lamp switch connector (A), and than remove stop lamp switch...