Hyundai Sonata: AVN System / AVN Remote Controller Repair procedures

Inspection
1.
Check for resistance between terminals in each switch position (LH).

[LH : Audio + Hands free]
Switch
Connector
Terminal
Resistance
(±5%)
SEEK Up
2-5
430 ?
SEEK Down
1.11 k?
MODE
2.11 k?
MUTE
3.11 k?
Volume (+)
4.61 k?
Volume (-)
6.81 k?
Voice
10.71 k?
SEND
18.91 k?
END
40.91 k?

2.
Check for resistance between terminals in each switch position (RH).

[RH : Audio + Hands free]
Switch
Connector
Terminal
Resistance
(±5%)
Cancel
3-5
330 ?
SET -
550 ?
RES +
880 ?
Cruise ON/OFF
1.44 k?
SCC (Following distance control)
5.54 k?
Group
2-5
560 ?
Trip Up
890 ?
Trip Down
1.45 k?
ENTER
2.55 k?

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel assembly.
(Refer to Steering System - "Steering Wheel")
3.
Remove the screw from the steering cover.

4.
Remove the steering back cover (A).

5.
Remove the steering remote control connector (A).

6.
Remove the steering remote control (A) after loosening the screws.

Installation
1.
Install the steering wheel remote control after connecting the connector.
2.
Connect the negative (-) battery terminal.
AVN Remote Controller Schematic Diagrams
Circuit Diagram ...

AVN Remote Controller (Sonata Sports) Components and Components Location
Components 1. Left remote control switch (Audio + Hands free)2. Right remote control switch (Cruise+Trip Computer)3. Paddle shift switch (Down)4. Paddle shift switch (Up) ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Front Door Module Repair procedures
Replacement 1. Remove the front door window glass. (Refer to Front Door - "Front Door Window Glass") 2. Remove the front door outside handle. (Refer to Front Door - "Front Door Outside Handle") 3. Loosen the front door outside handle base mounting screw (A). 4. Disconnect the outs ...

Hyundai Sonata LF 2014-2019 Service Manual: SRS Control Module (SRSCM) Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console. (Refer to Body - "Floor Console Assembly") 4. Pull up the lock (C), of the SRSCM connector, then disc ...

© 2018-2025 www.hsonatalf.org