| Replacement |
| 1. |
Completely open the movable glass using the panorama sunroof switch. |
| 2. |
Loosen he mounting screws (A) located at the side of the panorama sunroof deflector.
|
| 3. |
Using a screwdriver or remover, remove the panorama sunroof deflector (A).
|
| 4. |
Install in the reverse order of removal. |
Rear Glass Repair proceduresRemoval • In order to remove the rear glass, use the tools shown in the following figure: [Tooling Diagram] Square wire Insert-type wire grip [Tooling Assembly Diagram] • Insert and affix square wire into the insert hole of the wire grip ...
Roller Blind Repair proceduresRemoval 1. Open the roller blind using the panorama sunroof switch. • Leave 10 ~ 20cm (0.3937 ~ 0.7874 in) of the roller blind unopened...
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV terminals 1 and 2. 4. Check that the resistance is within the specification. Specification: Refer to “Specification” Removal 1...
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group). 3. Disconnect the injector connector (A). 4. Remove the installation bolt (B), and then remove the sensor from the cylinder block...