Hyundai Sonata LF: Panorama Sunroof / Roller Blind Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Body (Interior and Exterior) / Panorama Sunroof / Roller Blind Repair procedures

Removal
1.
Open the roller blind using the panorama sunroof switch.
   
•
Leave 10 ~ 20cm (0.3937 ~ 0.7874 in) of the roller blind unopened.

2.
Remove the roof trim.
(Refer to Roof Trim - "Roof Trim Assembly")
3.
Remove the roller blind bar (C) by pressing the top part of the lock pin (B) located on the both sides of the roller blind shoe (A).

4.
Put a fixed pin (B) into the hole located inside the groove of the right side roller blade side bracket (A). Becareful not to release tension.

5.
Remove the roller blind lower support (A) by loosening the mounting screws.

Installation
1.
Install the roller blind side bracket (A) fit into the guide groove (B).

2.
Tighten the mounting screws after installing the roller blind lower support (A).

3.
Remove the fixed pin (B) located inside the right side roller blade side bracket (A).

4.
Install the roller blind bar (A) on top of the roller blind shoe (B).

5.
Put the roller blind bar (A) into the roller blind shoe (B).

6.
Install the roof trim.
7.
Completely close the movable glass using the panorama sunroof switch.

    Panorama Sunroof Deflector Repair procedures

    Replacement 1. Completely open the movable glass using the panorama sunroof switch. 2. Loosen he mounting screws (A) located at the side of the panorama sunroof deflector...

    Panorama Sunroof Assembly Components and Components Location

    C..

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Passenger Airbag (PAB) Module Description and Operation


    Description Passenger Airbag (PAB) module is located in the passenger crash pad. This PAB contains 2 firing squibs of airbag and 1 firing squib of active vent. Depending of crash speed or the tightening of seat belt, it is decided a timing about both 2 firing squibs of airbag and 1 firing squib of active vent...

    Hyundai Sonata LF 2014-2019 Service Manual: Manifold Absolute Pressure Sensor (MAPS) Description and Operation


    Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal proportional to the pressure to the ECM. By using this signal, the ECM calculates the intake air quantity and engine speed...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org