Hyundai Sonata LF: Dual Clutch Transmission Control System / Input shaft speed sensor 1 Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / DCT (Dual Clutch Transmission) System / Dual Clutch Transmission Control System / Input shaft speed sensor 1 Repair procedures

Removal

1.	Remove the air cleaner assembly and air duct. (Refer to Engine Mechnical System - "Air cleaner")

2.	Remove the TCM. (Refer to Dual Clutch Transmission Control System - "TCM")

3.	Remove the battery and tray. (Refer to Engine Electrical System - "Battery")

4.	Remove the clutch actuator. (Refer to Dual Clutch Transmission Control System - "Clutch Actuator")

5.	Disconnect the input shaft speed sensor (A).

6.	Remove the input shaft speed sensor after removing the bolt (A-2ea).

Installation

Install in the reverse order of removal.

•	Before installing the input speed sensor,check the assembled state of the O-rings (A) and should apply gear oil to the surface of O- rings.

Input shaft speed sensor 1 Schematic Diagrams

C..

Input shaft speed sensor 2 Components and Components Location

C..

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Basic Service Symbols

General Information There are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service. SymbolMeaningDo not reuse the part. Replace a new one.Apply engine oil or transmission oil to the part...

Hyundai Sonata LF 2014-2019 Service Manual: Timing Chain Components and Components Location