Hyundai Sonata LF: Dual Clutch Transmission Control System / Input shaft speed sensor 1 Description and Operation
| Description |
| • |
Components location : DCT (Dual Clutch Transmission)
|
| • |
Function
The input shaft speed sensor is important in that it detects
the input shaft RPM and sends this information to the Transmission
Control Module (TCM).
It provides important input information for electric control.
The information is needed in all operations, including
feedback control, gear shift control and failure detection of other
sensors. |
Input shaft speed sensor 1 Specifications
Specification ItemSpecificationTypeHall effect sensorOperation condition (°C)°F(-40 ~ 150)-40 ~ 302Output signal (mA)High: 11.8 ~ 16.8Low: 5.9 ~ 8...
Other information:
Hyundai Sonata LF 2014-2019 Service Manual: Accelerator Pedal Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the mounting cap (A). 4. Remove the installation bolt (A), and then remove the accelerator pedal module...
Hyundai Sonata LF 2014-2019 Service Manual: Mode Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4. Verify that the mode control actuator operates to the vent mode when connected in reverse...
Categories
- Manuals Home
- Hyundai Sonata Owners Manual
- Hyundai Sonata Service Manual
- Ignition System
- Engine Control System
- Brake System
- New on site
- Most important about car
