| Specification |
| Item | Specification |
| Type | Hall effect sensor |
| Operation condition (°C)°F | (-40 ~ 150)-40 ~ 302 |
| Output signal (mA) | High: 11.8 ~ 16.8 |
| Low: 5.9 ~ 8.4 |
Input shaft speed sensor 1 Description and OperationDescription • Components location : DCT (Dual Clutch Transmission) • Function The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM)...
Removal 1. Disconnect the brake fiuid level switch connector, and remove the reservoir cap. 2. Remove the brake fluid from the master cylinder reservior with a syringe. Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water...
Components and Components Location Component Location 1. Horn switch2. Horn relay (Built - in Metal Core Block PCB)3. Horn (Low pitch)4. Horn (High pitch)5. Clock spring Repair procedures Removal 1. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") 2...