Blind Spot Detection Indicator Repair proceduresRemoval Blind Spot Detection Warnig Indicator 1. Disconnect the negative (-) battery terminal. 2. Remove the mirro (A). Installation Blind Spot Detection Warnig Indicator 1...
Inspection [Fuel sender] 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel pump assembly. 3. Using an ohmmeter, measure the resistance between terminals 1 and 6 of sender connector (A) at each float level...
Replacement 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A). Be careful not to damage to the wheel cap (A) when removing the it. 3. Remove the front wheel and tire (A) from front hub...