| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
| 3. |
Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw.
|
| Installation |
| 1. |
Install the coil antenna and connect the 6P connector. |
| 2. |
Install the crash pad lower panel. |
| 3. |
Connect the negative (-) battery terminal. |
Immobilizer Control Unit Repair proceduresRemoval 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3...
Ignition Switch Assembly. Repair proceduresRepair procedures Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3...
Removal and Installation Front Muffler 1. Disconnect the battery negative terminal. 2. Disconnect the rear oxygen sensor connector (A). 3. Remove the front muffler (A). Tightening torque: 39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft) 4...
T..