Hyundai Sonata LF: Front Suspension System / Front Strut Assembly Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Suspension System / Front Suspension System / Front Strut Assembly Repair procedures

Replacement
1.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the wheel cap (A).

   
Be careful not to damage to the wheel cap (A) when removing the it.
3.
Remove the front wheel and tire (A) from front hub.
Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

   
Be careful not to damage to the hub bolts when removing the front wheel and tire (A).
4.
Loosen the stabilizer link (A) and remove it from the shock absorber.
Tightening torque :
98.1 ~ 117.7 N.m (10.0 ~ 12.0 kgf.m, 72.3 ~ 86.8 lb-ft)

5.
Loosen the wheel speed sensor bracket bolt (A) and brake hose bracket (B).

6.
Disconnect the front strut assembly (A) with the knuckle by loosening the bolt & nut.
Tightening torque :
196.1 ~ 215.7 N.m (20.0 ~ 22.0 kgf.m, 144.7 ~ 159.1 lb-ft)

7.
Remove the front strut assembly and than loosen the strut mounting nuts (A).
Tightening torque :
53.9 ~ 73.5 N.m (5.5 ~ 7.5 kgf.m, 32.5 ~ 39.8 ~ 54.2 lb-ft)

8.
Installation is the reverse of removal.
Disassembly
1.
Compress the coil spring (A) with a SST (09546-26000).
Do not compress the spring more than necessary.

2.
Loosen the self locking nuts (C) from the strut (B).
3.
Remove the insulator, spring seat, coil spring and dust cover from the strut assembly.
4.
Reassembly is the reverse of the disassembly.
Inspection
1.
Check the strut bearing for wear and damage.
2.
Check the spring upper and lower seat for damage and deterioration.
3.
Compress and extend the piston rod (A) and check that there is no abnormal resistance or unusual sound during operation.

Disposal
(1)
Fully extend the piston rod.
(2)
Drill a hole on the (A) section to remove gas from the cylinder.

   
•
The gas coming out is harmless but be careful of chips that may tly when driling.

    Front Strut Assembly Components and Components Location

    C..

    Front Lower Arm Repair procedures

    Replacement 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A).     Be careful not to damage to the wheel cap (A) when removing the it...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting


    Waveform This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these signals. Generally CkPS signal is used to detect the piston's position and CMPS signal is used to detect the Top Dead Center of each cylinder...

    Hyundai Sonata LF 2014-2019 Service Manual: Schematic Diagrams


    Schematic Diagram Canister The Canister is filled with charcoal and absorbs evaporated fuel vapor from the fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by the ECM/PCM when appropriate conditions are set. Purge Control Solenoid Valve (PCSV) The Purge Control Solenoid Valve (PCSV) is installed in the passage connecting the canister to the intake manifold...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org