Hyundai Sonata LF: Tire Pressure Monitoring System / TPMS Receiver Description and Operation

Hyundai Sonata LF 2014-2019 Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Receiver Description and Operation

Description

1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state.
B.
In this state, there is no Auto-Location, no sensor wake-up, no sensor monitoring and no DTC monitoring..
C.
The state indicates that platform specific parameters must be written to the receiver and that sensors are un-learned.
(2)
Normal State
A.
In order for tire inflation state and DTC monitoring to occur, the receiver must be in this state.
B.
In this state, automatic sensor location / learning is enabled.
2.
Overview
A.
Learn TPMS sensor for under inflation monitoring automatically.
B.
Uses sensor information, distance travelled, background noise levels, Auto-learn status, short / open circuit output status, vehicle battery level, internal receiver states to determine if there is a system or a vehicle fault.
Operation
1.
General Function
A.
Auto-learn takes place only once per Ignition cycle.
B.
On successful completion, 4 road wheel sensor ID's are latched into memory for monitoring.
C.
Until Auto-learn completes, previously learned sensors are monitored for under inflation / leak warnings.
2.
General Conditions to Learn New Sensors:
A.
Receiver must determine that it is confident that sensor is not temporary:
a. Uses vehicle speed.
b. Uses confidence reduction of previously learned sensors.
B.
Typical time at driving continuously over 15.5 mph(25 kph) to learn a new sensor is up to 20 minutes.
3.
General Conditions to Un-Learn a sensor that is removed :
A.
It takes less than 20 minutes at 15.5 mph(20~30 kph).
B.
Confidence reduction is dependent on time which vehicle is driven at speed greater than or equal to 12.4 mph(20~30 kph).

    TPMS Sensor Repair procedures

    Replacement 1. Remove the tire. (Refer to Tires/Wheels - "Tire") 2. Remove the screw with torx driver (A).     • When installing the bead brake, make sure that it does not come in contact with the TPMS sensor...

    TPMS Receiver Schematic Diagrams

    C..

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Under Body Body Repair


    Projected Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Actual Measurement Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front side member tooling hole (O25)Side cover mounting hole (O9)Front sub frame mounting boltCenter floor side member tooling hole (O11)Center floor side member tooling hole (O16)Floor under cover mounting hole (O6...

    Hyundai Sonata LF 2014-2019 Service Manual: DCT (Dual Clutch Transmission) Repair procedures


    Removal 1. Remove the air cleaner assembly and air duct. (Refer to Engine Mechnical System - "Air cleaner") 2. Remove the TCM. (Refe to Dual Clutch Transmission Control System - "TCM") 3. Remove the battery and tray. (Refer to Engine Electrical System - "Battery") 4...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org