Hyundai Sonata LF: Airbag Module / Knee Airbag (KAB) Module Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Restraint / Airbag Module / Knee Airbag (KAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the mounting nuts (A).
4.
Disconnect the knee airbag connector (B).

Installation
1.
Disconnect the battery negative cable and wait for at least three minutes.
2.
Install the knee airbag.

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

3.
Install the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
4.
Reconnect the battery negative cable.
5.
After installing the knee airbag, confirm proper system operation.
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.

    Knee Airbag (KAB) Module Components and Components Location

    C..

    Airbag Module Disposal Description and Operation

    Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those installed in vehicle to be scrapped), the airbags or side airbags must be deployed...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Hazard Lamp Switch Repair procedures


    Inspection 1. Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch. AVN typeAudio typeNoDescription NoDescription 1GND1GND 2CAN _ High 2-3CAN _ Low 3- 4- 4-5Detent 5Detent 6ACC6Acc 7Battery (+)7Battery (+)8PAB Off 8PAB Off 9- 9Illumination (-)10- 10Illumination (+) 11SBR _ PS 11SBR PS 12- 12- 13Hazard lamp switch 13Hazard lamp switch 14- 14- 15IGN (+)15IGN (+)16- 16- Removal     • Wrap the protective tape on the tool to disassemble with the screwdriver or remover...

    Hyundai Sonata LF 2014-2019 Service Manual: Knock Sensor (KS) Description and Operation


    Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. When knocking occurs, the vibration from the cylinder block is applied as pressure to the piezoelectric element...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org