Hyundai Sonata LF: Front Door / Front Door Latch Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Latch Repair procedures

Replacement
1.
Remove the front door module.
(Refer to Front Door - "Front Door Module")
2.
To remove the front door outside handle base connector (A), widen both sides of the lock pins in the direction of the arrow and then push back the front door outside handle base connector.

3.
Remove the connector (A) by pressing the locking pin and seperate the wiring harness (B) on the upper of front door latch.

4.
Remove the front door inside handle cage (A).

5.
Remove the front door latch assembly (A) by pulling it in the direction of the arrow.

6.
Remove the front door outside handle base (A) by pushing in the lock pins located in the back.

7.
Remove the front door outside handle cable (A).

8.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Make sure the door locks / unlocks and opens / closes properly.
•
Replace any damaged clips.

    Front Door Side Weatherstrip Repair procedures

    Replacement 1. Loosen the front door checker (B) mounting bolt. 2. Detach the clips, then remove the front door side weatherstrip (A). Tightening torque : 16...

    Rear Door

    ..

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Windshield Deicer


    Components and Components Location Component Location Windshield deicer system prevent windshield wiper from freezing in the winter season. It consists of deicer in the lower part of windshield, switch and relay. Body control module receives an input signal from the front defroster switch, then controls relay...

    Hyundai Sonata LF 2014-2019 Service Manual: Power Window Switch Repair procedures


    Inspection Diagnosis with GDS 1. The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS). The diagnostic system (GDS) provides the following information. (1) Self diagnosis : Checking the failure code (DTC) and display (2) Current data : Checking the system input/output data state (3) Actuation test : Checking the system operation condition (4) Additional function : Other controlling such as he system option and zero point 2...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org