| Replacement |
| 1. |
Disconnect the negative (-) battery cable. |
| 2. |
Remove the glove box.
(Refer to Body - "Crash Pad") |
| 3. |
Remove faulty part and fit bracket assembly to new part.
|
| 4. |
Secure new part to vehicle and fit connector. |
| 5. |
Re-connect battery and turn Ignition on. |
| 6. |
After replacing the receiver, learn by using self-diagnosis device(GDS).
[Vehicle name input initialization]
[VIN input initialization]
[Wheel Sensor ID Writing (Wireless) initialization]
|
Inspection • Wrap the protective tape on the tool to disassemble with the screwdriver or remover. • Use caution in keeping and handling during disassembling/assembling because it is easily contaminated with lubricant and oil...
Adjustment Calibration (Setting up the zero angle) Steering Wheel Angle Sensor of a absolute angle type (CAN type) measures the angle under the standard of the zero angle set. Calibration must be performed as following cases. - Replacement of the Steering Wheel Angle Speed Sensor - Replacement or repair of the Steering column - Detection of DTC codes (C1260, C1261) - Replacement of the sensor cluster - Replacement of HECU Calibration procedure Perform wheel alignment and stand the steering wheel in a line within ±5°error...