| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
After loosening the bolts remove the main crash pad and cowl cross bar assembly together.
(Refer to Heater -"Heater Unit") |
| 3. |
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit") |
| 4. |
Separate the blower unit (B) from the heater unit (A) after loosening the screws.
|
| 5. |
Remove the heater unit lower case mounting clip (A). |
| 6. |
Remove the heater unit lower case (B) after loosening the mounting screws.
|
| 7. |
Pull out the evaporator core (A) from the heater unit.
|
| 8. |
Install in the reverse order of removal.
|
Heater Core Repair proceduresReplacement 1. Disconnect the negative (-) battery terminal. 2. After loosening the bolts remove the main crash pad and cowl cross bar assembly together...
Repair procedures ESP System bleeding This procedure should be followed to ensure adequate bleeding of air and filling of the ESC unit, brake lines and master cylinder with brake fluid. 1. Remove the reservoir cap and fill the brake reservoir with brake fluid...
Description The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater control unit and according to this signal the control unit regulates incar temperature to intended value...