Hyundai Sonata LF: Engine Control System / ETC (Electronic Throttle Control) System Repair procedures
Throttle Position Sensor (TPS)
| 1. |
Connect the GDS on the Data Link Connector (DLC). |
| 2. |
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Specification: Refer to “Specification”
|
|
ETC Motor
| 1. |
Turn the ignition switch OFF. |
| 2. |
Disconnect the ETC module connector. |
| 3. |
Measure resistance between the ETC module terminals 1 and 2. |
| 4. |
Check that the resistance is within the specification.
Specification: Refer to “Specification”
|
|
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Remove the resonator and the air intake hose.
(Refer to Engine Mechanical System - “Air Cleaner”) |
| 3. |
Disconnect the ETC module connector (A). 
|
| 4. |
Remove the installation bolts, and then remove the ETC module (A) from the engine. 
|
| • |
Install the component with the specified torques. |
| • |
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing. |
|
| 1. |
Install in the reverse order of removal.
Electronic throttle body Installation bolt:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.2 lb-ft)
|
|
| ETC module learning procedure |
When installing new ETC module or re-installing it, ETC module learning procedure must be performed.
| 1. |
Hold the ignition key or the start button at th IG ON position during 5 seconds. |
| 2. |
Turn ignition swich OFF and then start the engine. |
|
DTC codes (P0638, P2110) might be displayed if ETC module learning procedure does not performed after replacing ETC module. |
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density
type sensor and is installed on the surge tank. It senses absolute
pressure of the surge tank and transfers the analog signal proportional
to the pressure to the ECM...
Other information:
Description
Purge Control Solenoid Valve (PCSV) is installed on the surge
tank and controls the passage between the canister and the intake
manifold. It is a solenoid valve and is open when the ECM grounds the
valve control line. When the passage is open (PCSV ON), fuel vapor
stored in the canister is transferred to the intake manifold...
Inspection
1.
Turn the ignition switch OFF.
2.
Remove the ECTS (Refer to "Removal").
3.
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4.
4.
Check that the resistance is within the specification...
Manifold Absolute Pressure Sensor (MAPS) Description and Operation