| Description |
Never attempt to measure the circuit resistance of the airbag
module (squib) even if you are using the specified tester. If the
circuit resistance is measured with a tester, accidental airbag
deployment will result in serious personal injury. |
Inspection 1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform” Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt...
Removal and Installation 1. Remove the engine cover. 2. Disconnect the battery negative terminal. 3. DIsconnect the air duct (A). 4. Remove the air duct and air cleaner assembly. Tightening torque Hose clamp bolt: 2.9 ~ 4.9N.m (0...