Hyundai Sonata LF: Airbag Module / Passenger Airbag (PAB) Module Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Restraint / Airbag Module / Passenger Airbag (PAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Upper Cover Assembly")
3.
Disconnect the passenger airbag connector (A) and remove the PAB mounting bolts (B).

4.
Remove the crash pad.
(Refer to Body - "Main Crash Pad Assembly")
   
Replace the crash pad which that has been damaged after the PAB has been deployed.
5.
Remove the heater duct from the crash pad.
6.
Remove the mounting bolts from the crash pad. And then remove the passenger airbag.
   
The removed airbag module should be stored in a clean, dry place with the airbag cushion up.
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
3.
Place the passenger airbag on the crash pad and tighten the passenger airbag mounting bolts.

Tightening torque:
4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.4 lb-ft)

4.
Install the heater duct to the crash pad.
5.
Install the crash pad.
(Refer to Body - "Main Crash Pad Assembly")
6.
Tighten the passenger airbag crash pad mounting bolts.

Tightening torque:
9.0 ~ 11.0 N.m (0.9 ~ 1.2 kgf.m, 4.28 ~ 8.1 lb-ft)

7.
Connect the passenger airbag harness connector to the SRS main harness connector.
8.
Reinstall the glove box.
(Refer to Body - "Glove Box Upper Cover Assembly")
9.
Reconnect the battery negative cable.
10.
After installing the passenger airbag (PAB), confirm proper system operation :
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

    Passenger Airbag (PAB) Module Components and Components Location

    C..

    Side Airbag (SAB) Module Description and Operation

    Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Compressor Repair procedures


    Removal     Precautions for using the plastic pulley • Take care not to give physical impact to the plastic pulley. If exposed to the impact of dropping and collision, the pulley should not be used although not damaged. • Be careful not to place the pulley to downwards of the floor or table...

    Hyundai Sonata LF 2014-2019 Service Manual: Glove Box Upper Cover Assembly Repair procedures


    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org