Hyundai Sonata LF: Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Engine Control / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Inspection

Check signal waveform of CKPS and CMPS using a GDS.

Specification: Refer to “Waveform”

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Apply the engine oil to the O-ring.

•	Insert the sensor in the installation hole and be careful not to damage.

Install in the reverse order of removal.

Crankshaft position sensor installation bolt:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Crankshaft Position Sensor (CKPS) Schematic Diagrams

C..

Camshaft Position Sensor (CMPS) Description and Operation

Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the piston position of each cylinder which the CKPS can't detect...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Components and Components Location

C..

Hyundai Sonata LF 2014-2019 Service Manual: Exhaust Manifold Repair procedures