| Circuit Diagram |

Camshaft Position Sensor (CMPS) Repair proceduresInspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal • DON’T remove the camshaft position sensor while the engine is running or right after engine is turned off...
Components 1. Screw2. Front housing3. Stop ring4. Stopper5. Overrunning clutch6. Lever7. Lever plate8. Lever packing9. Magnet switch assembly10. Armature assembly11. Yoke assembly12. Brush (-)13. Brush holder14. Brush (+)15. Rear bracket16. Through bolt17...
Adjustment 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the lower crash pad. (Refer to Body - "Crash Pad") 3. Remove the knee airbag. (Refer to Rstraint - "Air Bag Module") 4. Confirm the gap between stop lamp switch and bracket...