| Specification |
| Pressure [KPa (kgf/cm?, psi)] | Output Voltage (V) |
| 50 (0.51, 7.3) | 0.3 |
| 600 (6.12, 87.0) | 2.5 |
| 1100 (11.2, 159.5) | 4.5 |

Fuel Pressure Sensor (FPS) Description and OperationDescription The fuel pressure sensor (FPS) is installed on the top of the low pressure fuel pump and measures the pressure in the low pressure fuel line...
Fuel Pressure Sensor (FPS) Schematic DiagramsCircuit Diagram Fail-Safe Mode Item Fail-Safe Output Voltage (V) 12 If the fuel pressure sensor malfunctions, it enters fail safe mode...
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the engine cover. 3. Disconnect the ignition coil connector (A). 4. Remove the ignition coil (A). • When removing the ignition coil connector, pull the lock pin (A) and push the clip (B)...
Component Location Index Engine Room [Theta 2.4 GDI] 1. Receiver-drier2. Condenser3. Service Port (High Pressure)4. Service Port (Low Pressure)5. A/C Pressure Transducer (APT)6. Compressor7. Suction & Liquid Tube Assembly8. Expansion Valve9...