Hyundai Sonata: Body (Interior and Exterior) / Hood
- Repair procedures
- Hood Assembly Components and Components Location
- Hood Assembly Repair procedures
- Hood Lift Repair procedures
- Hood Insulator Pad Repair procedures
- Hood Latch Release Handle Components and Components Location
- Hood Latch Release Handle Repair procedures
- Hood Latch Components and Components Location
- Hood Latch Repair procedures
Repair procedures
Replacement
•
Be careful not to damage the fender and body.
•
When removing the clips, use a clip remover.
1.
Remove the front bumpe ...
Repair procedures
Adjustment
1.
After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up or down, or right or left.
2.
Adjust the hood height by turning the hood overslam bumpers (C).
...
Other information:
Hyundai Sonata LF 2014-2019 Service Manual: Refrigerant Line Repair procedures
Replacement
1.
If the compressor is marginally operable, run the engine at
idle speed, and let the air conditioning work for a few minutes, then
shut the engine off.
2.
Disconnect the negative (-) battery terminal.
3.
Recover the refrigerant with a recovery/charging station.
4.
...
Hyundai Sonata LF 2014-2019 Service Manual: Rear Body Body Repair
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ]
Side outer panel rear cornerSide outer panel rear cornerSide outer panel rear cornerRear combination lamp mounting hole (O6)Rear bumper mounting hole (8.5X8.5)Rear bumper mounting hole (11X13 ...
© 2018-2021 www.hsonatalf.org