Hyundai Sonata: Hood / Hood Latch Repair procedures

Replacement
1.
Remove the front bumper.
(Refer to Front bumper - "Front bumper cover")
2.
Remove the head lamps [RH].
(Refer to Body Electrical System - "Head Lamps")
3.
Disconnect the connector (A), then remove the wiring mounting clips.

4.
Remove the hood latch (A) mounting bolts.

5.
Disconnect the hood latch cable (A) and remove the hood lower latch assembly (B).

6.
Install in the reverse order of removal.
   
Make sure the hood latch release cable is connected properly.
Make sure the hood locks / unlocks and opens / closes properly.
Adjust the latch alignment.
Hood Latch Components and Components Location
Component Location 1. Hood latch assembly ...

Trunk Lid
...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Repair procedures
Adjustment Inspect Glass Alignment 1. Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it. Alignment adjustment Standard value [mm(in.)] (1) Front edge : 0 mm (0 in.) (2) Rear edge : 0 mm (0 in.) 2. Completely open ...

Hyundai Sonata LF 2014-2019 Service Manual: Steering Angle Sensor Repair procedures
Adjustment Calibration (Setting up the zero angle) Steering Wheel Angle Sensor of a absolute angle type (CAN type) measures the angle under the standard of the zero angle set. Calibration must be performed as following cases. - Replacement of the Steering Wheel Angle Speed Sensor - Rep ...

© 2018-2022 www.hsonatalf.org