Hyundai Sonata: Lighting System / Hazard Lamp Switch Repair procedures

Inspection
1.
Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch.

AVN type
Audio type
No
Description
No
Description
1
GND
1
GND
2
CAN _ High
2
-
3
CAN _ Low
3
-
4
-
4
-
5
Detent
5
Detent
6
ACC
6
Acc
7
Battery (+)
7
Battery (+)
8
PAB Off
8
PAB Off
9
-
9
Illumination (-)
10
-
10
Illumination (+)
11
SBR _ PS
11
SBR PS
12
-
12
-
13
Hazard lamp switch
13
Hazard lamp switch
14
-
14
-
15
IGN (+)
15
IGN (+)
16
-
16
-

Removal
   
Wrap the protective tape on the tool to disassemble with the screwdriver or remover.
e caution in keeping and handling during disassembling/assembling because it is easily contaminated with lubricant and oil.
Use caution for the crash pad garnish and door trim upper garnish made of timber (Real wood) because they can be scratched or picked.
Be careful not to scratch the door trim and other parts.
1.
Disconnct the negative (-) battery terminal.
2.
Remove the center facia panel (A).

3.
Remove the center facia panel after disconnect the center facia panel.

4.
Remove the keyboard unit after loosening the screws.

Installation
1.
Install the hazard lamp switch.
2.
Install the center facia panel.
3.
Connect the negative (-) battery terminal.
Door Mood Lamp Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front Door Trim") 3. Disconnect the door mood lamp connector. 4. Remove the ...

Rheostat Components and Components Location
Components ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Description and Operation
Description The changed position of the seat by memorizing into the power seat unit with IMS switch controlling the optimal seat position set by the driver can be restored with the IMS switch. It has the function of prohibiting the restoring action during driving and emergent stopping the l ...

Hyundai Sonata LF 2014-2019 Owners Manual: Resetting the sunroof
Sunroof needs to be reset if the following occurs : - Battery is discharged or disconnected or the related fuse has been replaced or disconnected - The one-touch sliding function of the sunroof does not normally operate Reset procedure : 1. Place the ignition switch to the ON position or start the ...

© 2018-2025 www.hsonatalf.org